Owner`s manual

19.3 Cleaning
Fig.100
1. It will be necessary to clean the glass periodically. During startup,
condensation, which is normal, forms on the inside of the glass and causes
dust, lint etc. to cling to the glass surface. Initially paint, while curing, may
deposit a slight film on the glass. We therefore recommend that, during the
first few weeks of use, the glass is cleaned two or three times with non-
abrasive common household cleaners and warm water. Ammonia based
cleaners should not be used. Subsequently the glass should be cleaned two or
three times a season depending on the circumstances. Do not clean the glass
while it is hot.
2. Dust, etc. can be brushed from the ceramic fuel effects and firebox walls
after removing the front unit and opening the window.
Removing the front unit
• President FS: Remove top & unhook front unit – See figure 100
• President/Bolero ZC
: Unhook the front unit. Lift the front by holding the
decorative grille. Don’t lift by holding the top. See figure 101
• Windsor Arch
. Pull away the ashguard at the bottom and unhook the
Inner Cast Arch as shown in Fig. 102.
Opening the window (See figure 103)
Always securely replace the window before lighting.
45 of 48
Fig.101
The inside of the window can be cleaned by pulling forward and rotating the
two clamping bars at the top corners of the window and swinging
the window part way down. ! Be careful not to distort or
damage the spring-loaded bolts – Don’t swing the window
down more than is necessary!
To completely remove the window, also unscrew the two springs
loaded bolts at the bottom of the window. After refitting the
window apply light hand pressure against the window frame sides
to bed in the window seal.
Dust etc. can also be removed from the burner using a soft brush
after removing the ceramic fuel effects. Always completely
remove the window before removing the ceramic fuel
effects.
When cleaning, make sure that no particles are brushed into the
slots in the burner.
Fig. 102
Fig.103