Unit installation

To light the pilot.

 Push in the right control knob (the pilot lighting knob) and, while keeping it

depressed, turn anticlockwise through the ignition position marked and up to

the pilot position marked . The spark should light

the pilot. The pilot flame can be seen by looking

through the gap near the left side of the coal front (See

figure 4).

 When the pilot has lit, keep the right hand control

knob depressed for a few seconds to prevent the flame

supervision device from shutting off the gas supply

while its probe warms up, as explained above, then

release it. If the pilot does not remain alight turn the

knob back to the off position marked

•

Wait a few

seconds and repeat the lighting sequence.

To light the main burner.

 Partially depress the right control knob and turn to the main burner position

marked . The main burner should now light at its low position.

 The left-hand knob is for burner flame adjustment. Turning it anticlockwise should

gradually increase the flame height and heat output. Turning clockwise reduces the

flame height and heat output.

 The burner flame control does not have to be re-set every time the fire is lit. Once

set, it can be left at that position allowing you to use the right hand control only to

ignite the burner at the set flame height.

To Turn off the main burner only.

 Turn the right hand control knob to the pilot position marked .

To turn off the main burner and pilot.

 Turn the right hand control knob to the pilot position marked . Push the

knob in at this position and turn to the off position marked

•

CLEANING YOUR FIRE

Turn the fire off and allow it to cool completely before attempting any cleaning. Note

that the fire will retain heat for some time after it has been turned off.

Metal parts.

Clean the metal parts with a slightly damp cloth and then dry. Do not use abrasive

cleaners, they could scratch the surface.

OWNER GUIDE

Figure 4. Pilot flame (Fascia

may differ from that shown)

Page 46