Unit installation

15. FASCIA FITTING
If you have not done so already complete the information on the last pages of
this guide.
 Remove any protective film from the fascia.
 Locate the two lugs at the top of the fascia in the slots
in the convection box hood. Swing the bottom of the
fascia sides back against the convection box and lower
the fascia so that the lugs are fully seated in the slots in
the convection box hood (See figure 32).
 Refit the two screws to secure the bottom of the fascia
sides to the convection box side brackets.
Sonnet and Ultimate fascia.
 Fit the fire front casting between the fascia sides.
Locate the two screw heads at the rear top corners of the
casting through the keyhole slots at the inner sides of the
fascia. If the screw heads do not project
enough or project too far, the screws can be
adjusted. Lower the casting so that it rests on
the hearth (See figure 33).
 Place the bottom front cover casting in
position below the fire front casting.
Camden and Seattle fascia.
 Secure the knob to the front of the fire front
with the screw supplied.
 Fit the fire front between the fascia sides.
Locate the two hanging brackets at the
rear top corners of the casting through the
keyhole slots at the inner sides of the
fascia. Lower the fire front so that it rests
on the hearth (See figure 34).
INSTALLER GUIDE
Figure 34.
Figure 33.
Figure 32. Fascia fitting
© Baxi Heating U.K. Limited 2009.
Page 34