Unit installation

11. CERAMIC COALS INSTALLATION

This section is for models supplied with a ‘Coal’ fuel effect only.

For ‘Pebble fuel effect’ see section 12

The ceramic fuel effect may cause staining / discolouration to decorative surfaces. It

is therefore advisable to protect decorative surfaces.

1. Fit the ceramic coal into the fire above the burner.

The front of the ceramic coal should locate on the

horizontal faces but behind the vertical faces of the two

location brackets positioned at the front of the burner

module. See figure 18.

The coals should be positioned so that the arrows

always point towards the back of the firebox. When

located into position the stem of each arrow should be at

90° to the rear of the firebox.

2. Hold coal ‘A’ upright with the arrow pointing to the top.

Locate coal ‘A’ as shown in figure 19.

INSTALLER GUIDE

Figure 19.

Figure 18. Ceramic coal

base location

Page 28