Indoor Fireplace User's Manual

Programmable Remote Control

Setting the ﬂ ame

Use this setting when you want a particular ﬂ ame level. For instance, you

want to watch ﬂ ames burn at their highest level and you don’t mind if the

room is too hot.

To raise the ﬂ ame, press and hold the ▲ button until the flame gets to the

desired level. Let go.

To lower the ﬂ ame, press and hold the ▼ button until the ﬂ ame gets to the

desired level. Let go.

The ﬂ ame level will remain just as you set it.

Automatic ON/OFF

You can set your ﬁ replace to come on before you wake up and turn off after

you leave and then, turn on again just before you come home and turn off

after going to bed.

You can leave it like this for the heating season.

Decide what temperature you want your ﬁ replace to be at. Also, decide

what time you want your ﬁ replace to turn on and off. Finally, decide what

time you want it to come back on and off in the afternoon or evening. For

the ﬁ rst few times you set the timer, it’s handy to write these times down.

Set the temperature (just as you did in the section Setting the

temperature.)

Press the TIMER button and hold it until P1

☼ appears and flashes. Let

go. While ﬂ ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the

time at which you want your ﬁ replace to turn on in the morning.

Press the TIMER button and hold it until P1 ☽ appears and ﬂ ashes. Let

go. While ﬂ ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the

time at which you want your ﬁ replace to turn off when you leave.

Press the

TIMER button and hold it until P2 ☼ appears and ﬂ ashes. Let

go. While ﬂ ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the

time at which you want your ﬁ replace will turn on again in the afternoon.

Press the TIMER button and hold it until P2

☽ appears and ﬂ ashes. Let

go. While ﬂ ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the

time at which you want your ﬁ replace to turn off in the evening.

Note: If you want to set your ﬁ replace for only one time on and off, set P2

☼

and P2 ☽ for the same times as P1 ☽. The remote will record the P1 ☽ off

time for both P2 times.

To temporarily override the timer setting, just press AUTO or ▲ and ▼ to go

back to manual settings. Press TIMER to go back to your settings.

When your remote control displays BATT, you need to replace the battery

with a new 9 volt alkaline battery—6LR61/MN1604.