Use Instructions

14 of 20 UD00023.01
THIS DOCUMENT AND DATA ARE ISSUED IN STRICT CONFIDENCE AND ARE NOT TO BE
REPRODUCED IN WHOLE OR IN PART WITHOUT WRITTEN PERMISSION FROM MANAGEMENT
Form TMP_PRD0002.05 Released December 12, 2019
• If red or amber Warning LED flashes continuously, call
Ultradent Customer Service for repair
Light does not stay on for desired time
• Check Mode lights for correct input
• Check the Low power indicator for cell charge status
• Check that a fresh cell is properly inserted into the unit
Light is not curing resins properly
• Check lens for residual cured resins/composites
• Using proper amber UV eye protection, verify the LED
lights are working
• Check power level with light meter. If using a light meter,
Ultradent recommends checking the curing light in
Standard Power mode.
NOTE: Check the light before initial use to establish a
baseline for future readings. The true numeric output will
be skewed due to the inaccuracy of common light meters
and the custom LED pack the curing light uses. Light
meters differ greatly and are designed for specific light
guide tips and lenses.
• Check expiration date on curing resin
• Ensure proper technique is being followed according to
manufacturer recommendations
Battery will not charge
• Make sure the cell is inserted into the charger in the
correct orientation and allow cell to fully charge for about
1 hour
• If yellow lights on the charger do not change to green, call
Ultradent Customer Service to order replacement cells
and/or charger
• If neither green nor yellow lights on the charger are visible,
call Ultradent Customer Service to order or replace charger
and/or AC adapter
Charger does not charge battery
• Make sure charger is plugged in and AC adapter is plugged
into a working power outlet
• If green or yellow lights on the charger are not visible, call
Ultradent Customer Service for a new charger and/or AC
adapter
Cannot change modes with gestures.
Hold either single Power button down until a series of beeps
indicates the curing light is unlocked (approximately 9–10
seconds)
State
LED indicator
Low battery
Flashing red
Sleep mode
AF lock out
Diagnostic aid mode
White/violet
Curing mode
Pulsing blue