Use and Care Manual

For Deck or Dock Purposes:
Step 1: Creating the Flagpole Base
 Remove all pieces from the nylon carry bag. Remove bubble wrap from the
wheel mount base. Unfold the portable flagpole from the bracket.
 Locate the hole in the ground sleeve, which is 10” from the wheel mount
base. Make sure that that hole and the holes in the telescoping flagpole are
all aligned. With the holes aligned, connect the side hinge arms to the
flagpole, by inserting the silver bolt through the hinge arms, the ground
sleeve and the flagpole, anchoring the flagpole to the base. Tighten the lock
nut until snug. The hinge arms must be able to rotate on the pipe with a small
amount of tension.
 At this point, if you wish to mount the wheel mount base on your dock or
deck, use three woodscrews (not included) to secure the flat portion of the
bracket to the deck/dock surface.
Step 2: Attaching the Flags
 To attach your favorite flag use the enclosed flag clips. Attach the large flag
connector to the bottom of the flag. Likewise, attach the small flag connector
to the top of the flag. Slide the large flag connector to the desired location
and then slide the small connector onto the top of the flagpole. An extra-large
flag connector and a second large flag connector are included with this kit, if
you wish to fly a second flag below the top flag. After sliding the flag
connectors on the pole put the plastic ornamental silver ball into the top end
of the flagpole.
FOR TEMPORARY APPLICATIONS:
FIRMLY PULL AND TWIST each section to create the “friction lock” between each
section of the pole. The flagpole may stay extended in the vertical position
indefinitely, but may collapse with wind motion. If this occurs, simply re-extend the
pole and lock each section.
To collapse the pole, simply loosen the bottom section and gently lower the pole,
loosening each section.