Product Manual

Z41322A7 - Rev B
PHT-800#
4
Safety
Read and understand all safety information and become familiar with all safety symbols
contained in this section before moving, operating, or performing maintenance on this
equipment.
Safety Overview
The following general safety precautions must be observed during all phases of operation,
service, and repair of this equipment. Failure to comply with these precautions or with
specic safety messages elsewhere in this manual may impair the protection provided by the
equipment. Such noncompliance would also violate safety standards of design, manufacture,
and intended use of the instrument.
• Observe all safety signs posted in your facility.
• Observe warnings, cautions, handling information, storage requirements, and other
information on all container labels.
• Wear safety glasses with side shields.
• Wear the proper protective clothing, gloves, and other protective equipment before
handling any chemicals.
• Group the containers for the move by Hazard Class. Do not move acids with toxics or
oxidizers.
• Use maximum care and good judgment in preventing accidents and injuries and seeking
rst aid.
• Report unsafe conditions, equipment, practices, and on-job injuries.
• Understand your supervisor’s instructions. Ask questions if you do not know how to do the
job safely.
• Do not engage in tasks which you believe might be unsafe without consulting your
supervisor.
• Clean up the work area and equipment upon job completion.
• Before you start work on any electrical system or circuit, check all power sources to ensure
that the system or circuit is de-energized.
• Know the hazardous or potentially hazardous substances you work with or are present in
your work area. Review Material Safety Data Sheets (MSDS) on these substances, or contact
your supervisor.