User's Manual

-Confidential-
Valerann R&D
2
Installation Protocol - REV04”
d) At that point, the system should run and present the data from the road
at the server (i.e. cloud control center). The data can be displayed live
through a given link, a username, and password.
3. Safety and Precautions:
a) Any maintenance on the system will be done by Valerann personnel or an
approved contractor/electrician.
b) The antenna used for stud sensor transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter.
c) This device complies with FCC Rules Part 15. Operation is subject to two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference that may be received or that may cause
undesired operation.
d) Changes or modifications to this equipment not expressly approved by the party
responsible for compliance (Valerann Ltd.) could void the user’s authority to
operate the equipment.
e) This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.