Installation manual

13
Valcom, Inc.
5614 Hollins Road
Roanoke, VA 24019
540-563-2000 P.
540-362-9800 F.
www.valcom.com
Troubleshooting
What happens if the clock doesn’t power up?
Make sure the wiring is correct. If the clock is 24 volt, the power should be on the orange and yellow wires of the harness. If the clock is 110 volt,
the power should be on the black and white wires. The middle (green) wire is ground. If the wiring is correct, take a volt meter and measure the
voltage. For 24 volt models, the voltage should be between 14 - 28 volts. For 110 volt models, the voltage should read 85 - 135 volts.
What happens if the clock does not receive the signal?
Take the clock within close proximity to the transmitter and power the clock. If the clock does not correct, call Valcom technical support.
I have a location with a marginal signal. What should I do?
Try to install a repeater in a nearby area to the location or install a 110 volt clock.