Specifications

4 947169
Figure 5. Host Telephone System Connection
Figure 6. Telephone Mode Switch Setting
Figure 7. Power Cable
0dBm
OUT
LO W FREQ
CUT-OFF
GROUND
C1
RING
TIP
RIGHT
LEFT
GROUND
70V O U T PAG E IN
INPUTLEVEL
DUCKING
PAGEVOX
PAGEACCESSED
UNBALANCEDOUTPUT
OVERLOAD
POWER
MUSIC IN
DRYLOOPHIZ
DRYLOOP600OHMS
GROUNDSTART
LOOPSTART
GND
RING
TIP
C1
PAG E
IN P U T
TO
CO NTR O LLER
UNIT
GROUND
USE
TER M INALS or CON N E CTOR
MIC OUTPUT
EXISTING PAGING AM PLIFIER,
LOW VOLTAGE OUTPUTTO
TIP and RING
TIP AND RING FROM
LOO P START OR GRO UND
START PO RT
MIC SW ITCH
AM PLICENTER BACK PANEL
HOST
TELEPH O N E
SYSTEM
105 -120 VAC
210 -2 0 VAC
50 -60 H z
4
PAG E-IN
OPTIONS
Note: Connect the 4-wire RJ-11
type plug (used with telephones) to
the Page Input connector (far
right), or use the Page in
terminals.
Use Tip and Ring if installing to an
existing paging system (low
voltage output), VOX activated.
Use Tip and Ring if connecting to
a Loop Start or Ground Start
interface port in host telephone
system.
With a microphone, hook the mic
switch to C1 and Grd, and the mic
output to Tip and Ring.
6 FOOT
POW ER CABLE
PAG E IN
105 - 120 VAC
210 - 2 0 VAC
50 - 60 Hz
4
Note: Do not use extension
cords or plug into locally,
“safety-fused” outlets.