Specifications

3
Installation Steps -Continued
2. Connect music input wires to Left, Right, and Ground terminals if stereo, or Left and Ground if not (see Figure 3).
Note: The optional audio background music source can be a line level output from a CD or tape player, AM,
FM or commercial radio or other audio device.
3. Connect speaker cable to AmpliCenter (see Figure 4).
DO NOT connect speaker wires with AmpliCenter power plug connected!
Note: If more than one speaker cable is routed to the AmpliCenter, a connector block may be necessary.
Refer to sample wiring diagrams (page 9 - Figure 11). Consult the 70V wire gauge guide (page 4 – Figure 5) for
more specific information.
4. Set the AmpliCenter Telephone Mode Selection Switch (page 5 - Figure 7) to match the page output type of your
telephone system.
5. Connect host telephone system to Amplicenter (page 5 - Figure 6).
6. Insert power cord into AmpliCenter and into wall outlet (page 6 - Figure 8).
7. Test paging zone served by the AmpliCenter.
Figure 3. Music Input Connections on AmpliCenter
Figure 4. Speaker Connection on AmpliCenter