Tus neeg siv phau ntawv

If the flash unit is idle for long, please take out all batteries and keep
the flash unit in dry area.
NOMENCLATURE
01) Ring Flash Head
02) Locking Ring
03) Hot Shoe Stand
04) Dedicated Hot Shoe Contact
05) Output Level Indicator
06) Flash Power Level Button
07) Test Button
08) Battery Chamber Cover
09) Power Switch
10) Charging Indicator
11) External Power Pack Terminal Cover
12) External Power Pack Terminal
13) PC Sync Socket Cover
14) PC Sync Socket
1
2
3 4
5
6
7
8
9
10
11
12
13
14
INSTALLATION
Installing Batteries
1. Open the Battery
Chamber Cover.
Slide the battery
chamber cover along
the arrow direction and
then open it by thumb.
Mounting Ring Flash on the Camera
NOTE:
Take care of the hot battery when changing them after continuous flashes.
Take out of the battery when idle in case the battery leakage damages the flash
unit.
2. Insert the Batteries.
Install the batteries
according to the
direction indicated by
the sticker in the battery
holder and make sure
the + and - battery
contacts are correctly
inserted at the battery
compartment.
3. Close the Battery
Chamber Cover.
Slide the battery
chamber cover along
the arrow direction and
slide it back in place.
The battery chamber
cover will be locked
when there is a “click”
sound.
●Twist the mounting
lock anticlockwise to
loosen it to the highest
point.
●Slide the mounting foot
of control unit into the
camera's hoe shoe
completely.
●Twist the mounting lock
clockwise to tighten it.
1. Attach the Control Unit on the Camera
●To remove the flash, loosen the fixed knob and slide it out of the hot shoe of camera.
2. Attach the Flash Ring on the Camera.
6 types of adapter rings available to suit the camera lens: 49mm, 52mm,
55mm, 58mm, 62mm and 67mm.
Choose the adapter ring needed for your camera and attach to the camera
lens.
Mount the flash ring onto the adapter ring.