Daim Ntawv Qhia Tus Neeg Siv

P a g e | 1 www.holybro.com

#15019

PM06 V2-14S Power Module

Technical Specification：

 Input voltage: 2S-14S

 Power Module rated current: 60A

 Power Module max current: 120A (<60 sec)

 UBEC output: DC 5.1V~5.3V

 UBEC output current: 3A Max (Note: To ensure proper heat dissipation, UBEC output current needs

to be limited to <2A when using 14S battery.)

 Voltage Divider: 18.182

 Amperes per Volt: 36.364

Mechanical Specification:

 Dimensions: 35x35x5mm

 Mounting hole: 30.5mm*30.5mm

 Weight: 24g

Pin Map:

PAGE 1
#15019 PM06 V2-14S Power Module Technical Specification：  Input voltage: 2S-14S  Power Module rated current: 60A  Power Module max current: 120A (<60 sec)  UBEC output: DC 5.1V~5.3V  UBEC output current: 3A Max (Note: To ensure proper heat dissipation, UBEC output current needs to be limited to <2A when using 14S battery.)  Voltage Divider: 18.182  Amperes per Volt: 36.364 Mechanical Specification:  Dimensions: 35x35x5mm  Mounting hole: 30.5mm*30.5mm  Weight: 24g Pin Map: Page | 1 www.holybro.
PAGE 2
PX4 QGroundControl Setup  Connector the Power Module to battery and connect the flight controller to your ground station via USB.  Open QGroundControl go Vehicle Setup and Power tab and Input the Number of Cells.  Ensure the Voltage Divider & Amps per Volt is correct. For more information, refer to the PX4 Guide. Ardupilot Mission Planner Setup  Connector the Power Module to battery and connect the flight controller to your ground station via USB.
PAGE 3
Package Include：     1x Power Module 1x 80mm XT60 connector wire (pre-soldered) 1x Electrolytic capacitor: 220uF 63V (pre-soldered) 1x JST GH 6pin cable Page | 3 www.holybro.