User`s guide

User's Guide ______________________________________________________________________
192 __________________________________________________________________M210630EN-B
Resetting MAWS
To reset MAWS, give the command reset (recommended) or press the
reset button, see number 1 in Figure 138 on page 155.
0406-060
Figure 148 Reset Button on Logger
A short reset (pressing the reset button quickly) performs the same reset
as giving the command and starts the program again. A long reset
(pressing the reset button and keeping it down for a few seconds)
restarts the program with a so-called blank setup. A blank setup does not
run a configuration file.
Blank setup may be useful if the configuration is somehow defective
and does not allow the user to open a terminal connection. When the
blank setup is run, MAWS communication parameters are restored to
their defaults: COM0, 9600, N, 8, N, 1.
Determining Sensor Status
Sensor status values give indication about the general status of the
sensor interfaces. You have two alternatives to view the status value for
a sensor:
NOTE
Sensors with their own measurement interfaces and algorithms, for
example Vaisala Ceilometer or Vaisala Present Weather Detector, do
not appear in the sensor list of the Sensor Calibration tab.