User`s guide

Chapter 4 ________________________________________________________________ Installation
The recommended way to tighten the connector is to use the cable
tightening tool shipped with your WMT700. The ribbed part of
the tool offers a better grip of the cable when tightening the
connector. Insert the cable in the cable tightening tool as shown in
Figure 30 below. You do not need to remove the cable tightening
tool when the connector is tightened. For detailed instructions, see
Figure 25 on page 65.
1306-033
Figure 30 Tightening Connector with Cable Tightening
Tool
The following numbers refer to Figure 30 above:
1
=
WMT700
2
=
Cable tightening tool
3
=
Cable
VAISALA ________________________________________________________________________ 71