User`s guide

Chapter 4 ________________________________________________________________ Installation
1306-140
Figure 25 Attaching Connector to WMT700
NOTE
You do not need to remove the cable tightening tool after tightening the
connector;
you can leave it in place.
6. Hold the wind sensor from the enclosure and slide the
sensor into the mounting kit. Turn the sensor so that the
mounting screw slides into the appropriate slot. Do not
touch the array when handling WMT700.
To avoid misalignment, turn the sensor until the screw
reaches the far end of the slot. When the screw is in the
position indicated with number 3 in Figure 26 on page 66 or
number 2 in Figure 27 on page 67, tighten the screw.
7. Remove the transportation damper protecting the array and
store it for future use.
8. Align WMT700. For instructions, see section Alignment on
page 74.
9. Connect the cable to the data acquisition system and power
supply. For instructions, see section Wiring on page 77.
WMT700 is now ready for operation.
VAISALA ________________________________________________________________________ 65