User`s guide

Chapter 5 _________________________________________________________________ Operation
Operating WMT700 with WS425 and SDI-12
Profiles
In this section, each communication profile has its own section
listing the configurable parameters and the available commands
and data messages. For information on available commands and
data messages when using the WMT700 profile, see Chapter 5,
Operation, on page 107.
NOTE
For a complete list of the serial commands available for WMT700, refer
to
Appendix A, Complete Command Set for WMT700, on page 195.
Communication Profiles
In addition to the WMT700 and MES12 profiles, WMT700
supports the following communication profiles:
- WMT700
- ROSA - MES12
- WS425 - ASCII
- WS425 - NMEA Extended (version 0183)
- WS425 - SDI-12 (version 1.3)
- WS425 - ASOS
The profile has been preconfigured at the factory according to
your requirements specified when ordering WMT700. You can
change the profile through the serial interface, if necessary. For
instructions, see section Changing Communication Profile below.
Changing Communication Profile
The communication profile and other settings have been
configured at the factory according your specifications. You can
start using WMT700 directly after the installation with these
settings.
In case you want to change the communication profile, change
manually all needed parameters to match the new profile. The
needed configurable parameters are listed separately for each
profile in this manual.
VAISALA _______________________________________________________________________ 145