User`s guide

Chapter 5 _________________________________________________________________ Operation
Wind Measurement Control Commands
MEAS — Single Wind Measurement
This command starts wind measurement based on the user-
configurable averaging time. WMT700 does not send the data
message automatically. Use the polling command to fetch
measurement data in the required data message format.
MEAS
START — Start Continuous
Measurement
This command starts continuous wind measurement. Continuous
measurement starts when you exit the configuration mode or
restart WMT700.
You can retrieve data with a polling command or configure
WMT700 to send data messages at selected intervals. You can set
the interval for automatic messages with the autoInt parameter.
START
STOP — Stop Wind Measurement
This command stops continuous wind measurement.
To restart measurement, use the MEAS or START command.
You can fetch the most recent measurement data at any time with
the polling command.
STOP
VAISALA _______________________________________________________________________ 115