User`s guide

User's Guide ______________________________________________________________________
Example:
In this example the averaging time is shown to be 4 seconds.
G wndAvg
s wndAvg ,3.00000
BAUD — Display or Set Port Settings
This command shows or changes values of the serial port settings.
Set Port Settings
You can use the BAUD command to change the bit rate, parity
bit, data bits, stop bit, and communication profile of the selected
serial port. To restore default serial port settings, see Restoring
Serial Port Settings on page 186.
NOTE
There is a 100
-millisecond delay after which WMT700 takes the settings
into use. Do not send commands to WMT700 during this time.
BAUD x,y,z,w
where
x
=
Bit rate (300, 1200, 2400, 4800, 9600, 19200, 38400,
57600, or 115200)
y
=
Data bits (7 or 8)
z
=
Parity (n = none, e = even, o = odd)
w
=
Stop bits (1 or 2)
Example:
In this example the bit rate is set to 115200, data bits to 8, parity
to none, and stop bits to 1.
BAUD 115200,8,n,1
Display Port Settings
You can use the BAUD command to display the current serial
port settings.
BAUD
114 __________________________________________________________________ M211095EN-E