User guide

User's Guide ________________________________________________________
18 _____________________________________________________M210309EN-A
Table 4 I/O Connectors
Connector Description
X1 Plug-in connector with screw terminals (5 pcs)
for the anemometer cable. Maximum wire cross
section area is 1.5 mm
2
.
X2 Plug-in connector with screw terminals (8 pcs)
for the power and signal cable. Maximum wire
cross section area is 1.5 mm
2
.
X3 Plug-in connector with screw terminals (11 pcs)
for the wind vane cable. Maximum wire cross
section area is 1.5 mm
2
.
Sensor Wiring
The transmitter connects to the wind sensors with the cross-
arm's standard cables through two cable glands. Through
these cables the WAT12 transmitter both feeds the sensor
power and receives the wind data. Plug-in type screw
terminal connectors are provided both for the sensor cables
and the output line cable.
0206-048
Figure 10 Wiring of the Sensors