Owner's manual

6 VAISALA
To install drivers for Devices on a different subnet:
Note: vNet Devices are installed with Digi Driver software
(all Setup Wizard screens refer to Digi Drivers).
1 Insert the Vaisala vNet and Digi Device Drivers CD into the
PC where the drivers are to be installed.
If the Software Installation menu does not display automati-
cally, click
Start on the Taskbar, then select Run. Type
D:\setup.exe (replace ‘D’ with the drive letter of your CD-
ROM drive), then click
OK.
2 To check for most recent updates to the software installation,
click
Documentation Index.
•
vNet PoE Readme - review for updates to information in
t
he User’s Guide.
•
Digi Documentation Index - select the desired document
for the Digi
Device you are using.
3 On the Software Installation window, click vNet RealPort
Setup
.
• If the Welcome screen asks you to ensure that the vNet
Device is powered up and connected to the network,
disregard the message and click
Next.
•If the
Add a New Device option is displayed, select it, then
cl
ick
Next.
4 On the Select Device window, scroll to the bottom of the
device list, wait until “Searching...” is no longer displayed,
select
<Device not listed>, then click Next.
5 On the Describe Device window, enter the Device Model
Name (this name is on the serial number label, for example,
CDL-VNET-P).
6 In the Network Settings area complete the following:
•Enter the
IP Address obtained from your IT Department.
•S
et
No. Ports to 1.
•Set
Starting COM to the lowest COM port number that the
Setup Wizard di
splays.