User guide

Chapter 3: System Settings

3 Enter the following:

a Disconnect After Scan: To maintain a persistent con-

nection to the device, choose False.

b Connection Type: If the transmitter has a LAN or

WLAN module, select Network. If you use an external

Digi device, choose COM Port.

c IP Address: See your administrator or check the De-

vice box.

d Sample Rate: Choose 90 (recommended, but you can

modify the rate if you need more or less recorded da-

ta).

e Connection Timeout: To ensure continuous monitor-

ing, do not change. Contact your network administra-

tor if required.

4 To add several 300 Series Transmitters or a combination

of Vaisala Veriteq devices and 300 Series Transmitter

devices, select Upload Definitions File then enter or

browse to the correct file. To create a Definitions File,

see the FAQ on page 139.

Swapping Devices

If you need to send a device for maintenance (such as

recalibration), you will need to swap it for another device to

ensure continuous monitoring and alarming.

Note: If a device is removed without being swapped,

this will trigger a communication alarm.

When a device is swapped, the change is noted on the

Location History report (the report shows the device serial

number for a reporting period). If, during the reporting period,

the device was swapped, this event is listed in the report

summary.

To swap a device:

Ensure the new device has the same settings as the

device to be swapped (see

Options | System

Configuration | Locations Manager

, or refer to your

Vaisala product User Guide).