Operation Manual
Figure 21 TSC Monitor Menu
1. Select Menus > TSC Monitor.
2. To change to a
dierent task schedule, select File > Change TSC.
A list of previously configured task schedules appears. Select an item on the list to
change the TSC mode to that
configuration.
3. To start or stop tasks, place the cursor over the Command select a command.
Table 26 Task Start and Stop Commands
Command Description
Go (Schedule) Runs the task according to schedule.
Regularly scheduled tasks are typically used for routine IRIS operations. You can
create, test, save and recall schedules for dierent modes of operation.
Go (ASAP) Runs the task immediately, depending on the priority of other tasks. Use this for
interactive operation
STOP (When Done) Stops a task as soon as it finishes running.
STOP (Right Now) Stops a task immediately, even if the task is incomplete.
Interrupt/
Reschedule
Stops a task immediately and then reschedules it.
IRIS User Guide M211317EN-E
72