User Manual

Chapter 3 _____________________________________________ Configuring Modules and Sensors
VAISALA_______________________________________________________________________ 81
Configuring Absolute Shaft Encoder
To add the absolute shaft encoder into your system setup, proceed as
follows:
1. Go to the Equipment view of Lizard Setup Software and select
QSE104 from the Available list, see Figure 38 on page 81.
2. Connect QSE104 to an available serial port.
0711-144
Figure 38 Equipment View: Absolute Shaft Encoder
Connected to Optional DSI486 Module
3. Go to the Measurements view. All the parameters are predefined.
If there is more than one device on the same RS-485 line, the
device IDs must be different. See Figure 39 on page 82.