User Manual

User's Guide ______________________________________________________________________
70 __________________________________________________________________ M210933EN-C
2. Proceed to the Equipment view; see Figure 29 on page 70.
a. Scroll down the Available list box for USA-1.
b. Click on the Add button to select USA-1.
c. Double-click the Connector list for USA-1 in the I/O
Connections frame in order to select the COM port.
0711-136
Figure 29 Equipment View: Selecting I/O Connection for
Ultrasonic Anemometer
Using Sensor Variables in Reports
You can use the variables received from the ultrasonic anemometer in
Lizard Setup Software like those from any other sensor.
To check which variables are available, proceed as follows:
1. Select the Reports view; see Figure 30 on page 71.
2. Create a new report or select an existing one to include the
variables for the ultrasonic anemometer (Metek_1).
3. Click Metek_1 in the Available list box in the Select variables
frame.