User Manual

Chapter 3 _____________________________________________ Configuring Modules and Sensors
VAISALA_______________________________________________________________________ 69
Configuring Ultrasonic Anemometer
Proceed as follows:
1. Configure the ultrasonic anemometer hardware in the Optional
hardware view; see Figure 28 on page 69.
- In this example, DSU232 has been selected for use (having an
RS-232 interface).
- It is recommended that you keep the default settings in the
Line parameters frame.
0711-135
Figure 28 Optional Hardware View: Configuring DSU232
for Use with Ultrasonic Anemometer