User Manual

User's Guide ______________________________________________________________________
52 __________________________________________________________________ M210933EN-C
In the Reports view, the input statuses are available as individual
variables IN0 through IN7 and combined as bits into a single status
word ALL. The input module status is also available for the sensors;
refer to Figure 16 on page 52.
0711-114
Figure 16 Reports View: Digital Inputs in Report
Reporting Outputs of the Digital I/O Module
You can also include the state of the output pins in the digital I/O
module in your reports. To report the output states, proceed as follows:
1. Open an existing setup in the Setup view or create a new one.
2. Go to the Reports view.
3. Open the available variables in the Select variables frame. Select
QMI108_1 to list all the possible variables. Variables
OUT0 ... OUT7 provide the state of the individual output pin.
4. Add the variables into your report.