User Manual

User's Guide ______________________________________________________________________
322 _________________________________________________________________ M210933EN-C
3. In the Communication interfaces view, create and configure a
logical interface for the Windows Null modem. The parameters to
configure are outlined in Table 70 on page 322.
0710-122
Figure 161 Configuring Null Modem
Table 70 Null Modem Parameters
Parameter Value
Incoming Yes
auth PAP
username User name available for logging in to
the data acquisition system using
PPP dial-in. Use pppuser as value.
password Password for the user name. Use
userppp as value.
staticip Yes
vjompress Yes
servername Name seen by external devices
when dialing in to the QML logger
NOTE
In this configuration, the QML logger has no domain name service
configured, so it is not capable of accessing IP services by name, but
only by using IP addresses. If it is necessary to access services by
name, at least one DNS server (dns1) must be available and configured
in the QML logger. DNS settings can be obtained from a Windows PC
by opening a command prompt and issuing the command ipconfig /all.