User Manual

User's Guide ______________________________________________________________________
306 _________________________________________________________________ M210933EN-C
5. In the IP Services view, add and configure a virtual COM port for
service access as shown in Figure 146 on page 306.
0711-183
Figure 146 Configuring Virtual COM Port for Service
Access
a. Add a virtual COM port by selecting Virtual COM Port in
the Available list and clicking Add.
b. Configure the following items for the virtual COM port:
- Select the Service connection enabled option.
- Select the Passive connection, Accept incoming option.
Table 67 Settings for NTP Client
Setting Description
Server 1 Primary NTP server to use
Server 2 Secondary NTP server to use
Primary interface netif0, that is, the GPRS/GSM modem you have
previously added in the Devices view
NOTE
If you using a public NTP server, it is recommended that you select a
server close to the weather station location, for instance, a server
located in the same country.