User Manual

User's Guide ______________________________________________________________________
304 _________________________________________________________________ M210933EN-C
c. Create another communication interface dedicated for the
incoming service connection. Change the following settings:
- Allow incoming connections by changing the interface
setting Incoming to the value Yes.
-Leave the isp parameter blank. This interface must not be
used for outgoing connections.
- Select the value Yes for the staticip parameter.
3. In the IP Services view, add and configure an FTP client for
sending reports.
0710-113
Figure 144 Configuring FTP Client
a. Add an FTP client by selecting FTP Client from the
Available list and clicking Add.
b. The settings to configure for the FTP client are outlined in
Table 66 on page 305
NOTE
The user name and/or password may be left blank if they are not
required by the network operator.