User Manual

Chapter 5 __________________________________________ Configuring TCP/IP-Based Telemetry
VAISALA______________________________________________________________________ 243
The parameters for messages transmitted using the SMTP client are
listed in Table 37 on page 243.
Table 37 Parameters for Sending Reports via E-Mail
Parameter Use
Sender Fixed message sender identity.
Alternatively, option Use sname@domain
as sender can be used. See later in the
chapter for naming formats
Recipient E-mail address for message recipient
Subject Message subject. Alternatively, an external
source for subject or option Use default
subject can be used. See immediately
below this table for naming formats
External subject source/
Variable
Optionally message subject can be
generated by external source, typically by a
report. Enter here the source and variable
in the source.
Options: Send only when
timed
Do not send the message immediately
when created, but when triggered by 'E-
mail transmit' timer. This timer needs to be
manually enabled from the timers view. See
section Automatic and Timed Transmission
of E-Mail Messages on page 244.
Options/Use default subject Use built-in default for message subject.
See naming formats after this table.
Options/Use local time Use local time when generating timestamp
for the default subject.
Options/Use sname@domain
as sender
If the source domain is set in the generic
SMTP configuration, it can be used with
station name to construct sender identity.
See naming formats after this table.