User Manual

Chapter 5 __________________________________________ Configuring TCP/IP-Based Telemetry
VAISALA______________________________________________________________________ 213
Table 28 Station-Specific Parameters for Communication
Interfaces
Parameter Use Example or Allowed Values
apn Access point name internet, vaisala.fi
auth Authentication type none = no authentication; any
= PAP or CHAP; pap = PAP;
chap = CHAP
auth_both Authenticate both peers. In addition to the
client (AWS) authenticating to the server,
the server must authenticate to the client. If
the parameter value is set to yes,
authentication credentials must be added to
the parameter group pppclients. For
further information, see Authentication on
page 217.f
Yes = true
username Outgoing username registereduser
password Outgoing password mysecret
servername Identity when acting as server. The default
value is the station name.
MAWS, AWS
isp ISP number to dial GPRS connection: *99***1#
Dial up: 01234567
staticip Static IP address in use Yes = true
address IP address if static
10.0.0.1
1
1. Used only if the staticip option is selected.
subnetmask Network mask
255.255.255.0
1
gateway Gateway if static
10.0.0.2
1
dns1 Domain name server 1. It is recommended
that you leave this setting blank unless you
use a static IP address or do not obtain a
DNS server from your network in DHCP or
PPP negotiation.
10.10.10.10
dns2 Domain name server 2. It is recommended
that you leave this setting blank unless you
use a static IP address or do not obtain a
DNS server from your network in DHCP or
PPP negotiation.
10.10.10.11
ifpriority Usage priority for interface. Defines the
routing preference for packets: the open
interface with the highest priority will be
used.
1 ... 9; 1 = lowest priority, 9 =
highest priority
vjcompress Use IP header compression Yes = true
autoinit Automatic DSE101 startup Yes = true
autoinitinterval Interval (in milliseconds) after which
automatic startup of the interface is retried if
it initially fails.
5000