User Manual

User's Guide ______________________________________________________________________
158 _________________________________________________________________ M210933EN-C
Table 15 Available Output Variables
Variable Data Type Description
check_errs Integer Number of the failed downlink checksums
conn_GCC Integer Number of the connected ground stations (GCC)
inbound_message String Content of the latest inbound message
inbound_sender String Sender of the latest inbound message. If the sender is listed
in the speed dial list in the GCC, only the number is
available instead of the full internet address, for example,
OR08
inbound_subject String Subject of the latest inbound message
inbound_time String UTC time when the latest inbound message was received
lat Float Latitude from GPS
lon Float Longitude from GPS
msg_num Integer Number of the next message to be sent to the
communicator (SC). For example, when two messages
have been sent to communicator, the value is three
pass_msg_num Integer Number of the message that has been acknowledged by
gateway last, i.e., successfully transmitted. Value is
available after first transmission. Not applicable with
globalgrams.
pos_qual Integer Quality of the position information:
0 = GPS
1 = Good doppler ...
15= Poor doppler
qi_msgs Integer Number of inbound messages in SC
qo_msgs Integer Number of outbound messages in SC
sat_in_view Integer The ID number for the currently visible satellite. Zero if none
is visible.
sr_status Integer Status code from the last system response. The code is
available after first transmission. For details, refer to the
Orbcomm specification.
st_diag_code Integer Internal diagnostic code. For values, refer to the Orbcomm
SC specification.
status Integer General interface status:
0 = OK
1 = SC not accessed yet
2 = Reserved for future use
3 = Communication timeout
4 = Reserved for future use
5 = SC reports internal failure
6 = SC queue full
stored_sats Integer Number of the stored orbital elements. This indicates how
many different satellites the SC has acquired.
UTC String Current UTC date and time from GPS. Example: Thu Nov
01 11:35:16 2007