User Manual

Chapter 4 ________________________________________________ Configuring Telemetry Options
VAISALA______________________________________________________________________ 155
Configuring Communications
The ORBCOMM communications parameters are configured in the
Device configurations view as shown in Figure 73 on page 155. For the
parameter values, refer to Table 14 on page 155.
0711-182
Figure 73 ORBCOMM Configuration
Table 14 ORBCOMM Communicator Parameters in Lizard
Parameter Value Description
Gateway
number
List of active GCCs
can be obtained from
the ORBCOMM web
site
Number of the destination GCC
Message type Standard message Preferred message type: Direct
communication from the remote site
to GCC via satellite
Globalgram Messages are on the queue in
satellite until link can be established
between satellite site and receiving
GCC
1
Enhanced
globalgram
Same as previous but you may use
an e-mail address instead of the
speed dial
1
Report Short (max 5-byte) data report