User Manual

User's Guide ______________________________________________________________________
116 _________________________________________________________________ M210933EN-C
4. Proceed to the Measurements view to configure the sensor
interface as shown in Figure 63 on page 116.
0711-150
Figure 63 Measurements View: Configuring Serial Sensor
Interface
Typical items to configure include the following:
Item Description/Use
Device ID Device identifier (must be entered)
- Same as the set
- Unique for each sensor if multiple devices are
connected to the same serial line
Used by
- Polling and data reception to identify the device
- Open commands to identify which device should
open its service interface
Mode Configuration for automatic or polled operations as
described in section Data Acquisition Methods on page
110.
Message
Type
Many devices support data messages with different
contents. This item selects the expected message type.