User Manual

User’s Guide ______________________________________________________________________
50 ___________________________________________________________________M210785EN-E
Introduction to Lizard User Interface
The basic function of Lizard Setup Software is to create different setups
for the QML logger. A setup is created by going through all the Lizard
modules, which in this manual are referred to as views. For further
information on creating and modifying setups, refer to section Setup
Management on page 56.
An example view of the user interface is presented in Figure 22 on page
50. Work in the views from left to right. This means that you usually
have to select some items in the upper left of the view and then
configure or edit the details on the right of the view. In other words, you
work from left to right and towards greater detail.
On the lower left of each view there is an information pane which is
used for both a page help and for displaying general help information
on selected items. These help systems will be further discussed in
section Online Help on page 55.
Configurable items in bold print can usually be edited. For example,
you can rename parameters by double-clicking on the item.
1004-059
Figure 22 Example View of User Interface
The following numbers refer to Figure 22 on page 50:
1 = Toolbar
2 = Information pane