User Manual

User’s Guide ______________________________________________________________________
204 __________________________________________________________________M210785EN-E
Creating Checksum Report
To use the checksum option in a report, proceed as follows:
1. In the Reports view, open the available variables in the Select
Variables frame. The configurable checksum report in this
example is MyReport; see Figure 105 on page 204.
0711-124
Figure 105 Reports View: Configuring New Checksum
Report
There are variables in the list that are used for calculating and
showing the checksum:
- CRC returns the checksum to be formatted in a User format
- CRC_start indicates the start of data to be included in the
CRC
- CRC_end stops calculating the CRC
- CRC_string returns the checksum in an ASCII presentation