Owner`s manual

Installation

Mounting unit using Velcro fasteners

Emulation Mode Selection (2002-2004 SC430)

Special Emulation Mode programming steps:

@ Properly install this unit.

@ Put “Left” programming switch in “DOWN” position.

@ Put ignition switch into the “ACC” position.

@ Wait for long beep followed by a few short beeps. This may take up to one minute.

@ Put ignition switch into the “OFF” position.

@ Return programming switches into their default position (both switches “UP”). Wait at least 10 seconds.

@ Put ignition switch into “ACC” or “ON” position.

@ Check SoundLinQ2 for functionality, especially TEXT capabilities.

Ignition into

“ACC” or “ON”

position

Both

switches

“UP”

Ignition into

“OFF” position

up to 30 sec

Confirmation beep

Left

switch

“DOWN”

“Hard” Velcro Fastener

Carpet or car chassis

SoundLinQ2

“Soft” Velcro Fastener

! Velcro Fasteners are not included

! VAIS Technology strongly recomand to ground unit to the car chassis for best results

! Do not more the 5mm size screws. Using screws larger then 5mm may damage the PCB board.

NOTE

M4 x 5mm*

(see note below)