Owner`s manual

Installation

We strongly recommend that you install the unit in an easily accessible location, so you can later upgrade

the unit or re-program it in case of incorrect programming.

IMPORTANT

CD-MP3 Emulation Mode Selection (CD-MP3 emulation)

CD-MP3 Emulation Mode programming steps:

@Properly install ML+ player.

@Put the “Left” programming switch in the “DOWN” position.

@Put ignition switch into the “ACC” position.

@Wait for a long beep followed by a few short beeps. This may take up to one minute.

@Return programming switches to their default position (both switches “UP”).

Wait up to 30 seconds until confirmation beep.

@Put ignition switch into the “OFF” position.

@Wait at least 10 seconds.

@Put ignition switch into “ACC” or “ON” position.

@Check SoundLinQ for functionality, especially TEXT capabilities.

Ignition into

“ACC” or “ON”

position

Both

switches

“UP”

Ignition into

“OFF” position

up to 30 sec

Confirmation beep

Left

switch

“DOWN”

Mounting unit using Velcro fasteners

! Velcro Fasteners are not included

! VAIS Technology strongly recommends grounding the unit to the car chassis for best results.

! Do not use any screws longer than 5mm. Using screws larger then 5mm may damage the PCB board.

NOTE

Carpet or car chassis

“Soft” Velcro Fastener

“Hard” Velcro Fastener

ML+ (MediaLinQ Plus)

M3 x 5mm*

(see note below)

WARNING

We strongly recommend to Ground ML+ to the vehicle’s chassis