Owner's Manual

&wARNING
DO NOT DISASSEMBLE OR ALTER
Doing so may result in an accident , fire or electri c shock
Do not block the airbag
Before You Start 3
Do not mount product or any added aud io and / or video equipment where it can obstruct the operation of any sa f ety
devices such as the airbag .
Distraction Warning
Do not let product or any added audio and/or video equipment distract you while you are driving .
BEFORE WIRING , DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY T ERMINAL
Before starting any installation work , you must wait 90 seconds after turning the ignition switch to the LOCK pos iti on and
disconnecting the negative(-) terminal from the battery. The supplemental restraint system (airbag) is equipped wi th a
backup power source . If installation work is started less 90 seconds after disconnection of the negative (-)battery terminal ,
the SRS may deploy . When the negative(-) terminal cable is disconnected from the battery the clock and audio systems
memory will be erased. Before starting installation work make a record of the clock and audio systems memory settings .
When installation is complete , reset the clock and audio systems to their previous settings . Power tilt , power telescopic
steering column, front power seats, power mirrors , and power shoulder belt anchorage are equipped with a memory
function . Th e rear power seat is not equipped with a memory function. e and they can make a record of the memory
contents, rear power seat is not equipped with the memory function. When installation is complete , it is necessary to
readjust the features to their previous settings Never use a backup power supply (such as another battery) during
installation work to avoid losing these memory settings.
& CAUTION
DO NOT SPLICE INTO ELECTRICAL CABLES
Never cut away cable insulation to supply power to other equipment. Doing so will exceed the current carrying capac i ty of
the wire and result in fire or electric shock .
DO NOT ALLOW CABLES TO BECOME ENTANGLED IN SURROUNDING OBJECTS
Cables or wiring that obstruct or get caught on places such as the steering wheel , shift lever , brake pedals , etc. can be
extremely hazardous .
DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST
Moisture or dust may result in product failure.
HAVE THE WIRING AND INSTALLATION DONE BY EXPERTS
The wiring and installation of this product requires special techn i cal skills and experience .
USE ONLY SPECIFIED ACCESSORY PARTS
Use of other than specified parts may damage product internally .
Follow the operational and installation manuals.
YOU SHOU LD READ AND FAMILIARIZE YOURSELF THOROUGHLY WITH THE FOLLOWING INFORMATION PRIOR
TO INSTALLING AND USING THIS UNIT. IN ADDITION, YOU MUST CAREFULLY READ AND FOLLOW THE
INSTALLATION SCHEMATICS/INSTRUCTIONS FOR THE PRODUCT AND THE VEHICLE IN WHICH IT IS BEING
INSTALLED . FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS MAY DAMAGE THE PRODUCT AND THE
VEHICLE , WILL VOID THE PRODUCT WARRANTY, AND MAY VOID THE VEHICLE WARRANTY .
Check your local laws
Some States / Provinces or other governmental jurisdictions (such as cities) may have laws that prohibit the operat i on of a
video screen within the sight of the Driver. If you have purchased such a product , you should use the product on ly in
locations where it is legal to do so, and if you do use the product, set up the screen so it is only visible to passengers .
TROUBLESHOOTING
Should this product fail to operate properly , please contact your Dealer or our Customer Service Department at
info@vaistech . com.
(l) IMPORTANT
This unit is an interface adapter for Toyota/Scion head unit to control the SiriusXM Tuner SXV300 (SOLD SEPARATELY) .
(J) About SiriusXM Satellite Radio Operation
The unit may refuse to change the channel if your reception is going ON and OFF.
Please wait until your reception stabilizes in order for the unit to allow you to change the channel easily.
Due to bad reception in some areas, SiriusXM Satellite Radio may not work and / or not able to disp l ay text.