User Guide

2.6.1 Monitor Extension Setting
Caution: Don’t setting monitor extension before setting “Door” successfully.
: Click “One Circle Button” to enter the next system settings page.
The pre 2digit means floor number, last 2digit means extension number. If
one room need more indoor monitor, then can set with Extension number, For
example: Room 0201 need 3more monitor, can set them to be 0202,0203,02
04. One room max support 4 monitor.
When you input the extension number that need to click “OK” to set
successfully.
Apartment system systemExtension unit setting
Change the last two digits into 02 or other digit. (01 means master unit, the
rest are slave units)
2.6.2 System Password Setting
Click “System Password” to enter the setting menu that input the old passcode
“666 666” firstly. And new passcode need to input twice, then, click “OK” to
set successfully.
2.6.3 System Reset
Click “System Reset” to have a notification whether “Reset system”. And click
“OK” to reset the system successfully that clean all settings what you changed
and records in the monitor, then, it will be the Factory Settings Default. Click
“Cancel” will return the System Settings Menu. As picture 2.6.3.
2.6.4 IP Camera Setting
1). Support IP Camera Protocol: Onvif or RTSP (Reference Brand:
HIKVISION or Dahua).
2). When you connected the IP Camera, need to set “IP Address” in the same
network segment between “IP Camera” and “Indoor Monitor”.
Pic 2.6.3
Pic 2.6.2
Pic 2.6.1.1
Pic 2.6.1.2
Pic 2.6