Operation Manual

37GBInstallation instructions VRT 360f
The receiver is equipped with two status
LEDs
. In order to see these you must
remove the cover of the receiver
housing. The LEDs provide the following
information for the system:
LED Condition Function
green on
off
Operation OK
Operation fault
red off
on
flashing
Operation OK
Radio signal/eBus error
Reception of a radio signal
Table 11.1 Displays
11.1 Installer level
Press the P button to access the installer
level.
• Push the button P for approx. 10
seconds
The spanner symbol and the first
parameter appear in the display.
• Press the dial. You can select all the
system parameters in turn.
Turn the dial to set the values you want.
When you press the P button the display
returns to basic mode.
You can select and change the following
parameters:
Start-up 11