Operating and installation manual timeSWITCH 150 GB, IE, ES, PT
For the owner and heating engineer Operating and installation manual timeSWITCH 150 24-hour timer GB, IE
Contents Contents 2.3 2.4 2.5 2.6 2.7 Setting slides ................................... 9 Setting the heating program....... 9 Weekend mode ............................... 9 Summer time mode ....................... 9 Power failure ................................... 10 Safety . . . . . . . . . . . . . . . . . . . . . . . . . 5 3 Recycling and disposal . . . . . . . . 10 Operating instructions . . . . . . . . . . . 5 Installation manual . . . . . . . . . . . . . .
Contents 5 Safety instructions and regulations. . . . . . . . . . . . . . . . . . . . . . . 13 5.1 Safety instructions ........................ 13 5.2 Regulations ...................................... 14 6 Installation . . . . . . . . . . . . . . . . . 14 7 Start-up . . . . . . . . . . . . . . . . . . . . 16 8 Handing over to the owner . . . . 17 9 Customer service and warranty 18 10 Technical data . . . . . . . . . . . . . . .
Notes on the documentation Notes on the documentation The following information is intended to help you throughout the entire documentation. Further documents apply in combination with this operating and installation manual. We accept no liability for any damage caused by failure to observe these instructions. Other valid documents Operating and installation manuals for all system components 4 Symbols used Please observe the safety instructions in this manual.
Notes on the documentation; Safety; Description of the device 1 Storage of the documents Please pass on this operating and installation manual to the owner of the system so that it is available whenever it is required. Safety The timer must be installed by an approved specialist, who is responsible for the observance of the relevant standards and regulations.
1 Description of the device Overview of the device 1 2 12 5 3a 9 3 6 Key 1 Minute hand 2 Time mark 3a Slide pushed in (boiler on) 3b Slide pulled out (boiler off) 4 Time of day 5 Operating mode switch 3b 4 Fig. 1.
Description of the device 1 Minute hand (1) For displaying and setting the time. Time mark (2) The triangular time mark indicates the time of day (e. g. 3.00 pm in Fig. 1.1). Slide pushed in (3a) The boiler is switched on by a pushed in slide and remains on until the timer arrives at a pulled out slide. Time of day (4) The time of day is indicated by the time mark of the movable number ring with the time of day. The time of day is indicated by a 24-hour scale.
2 Operation 2 Operation 2.1 Selecting the operating mode You can use the operating mode switch (5) to change the operating mode of your boiler as desired. – The boiler is switched off permanently if set to “off”. – The boiler is switched on permanently if set to “on”. – The boiler is time controlled according to the slide settings if set to “ ”. 8 2.2 Setting the timer Viewing the time of day The time of day is indicated by the number ring on the time mark (2). Note! The timer has a 24-hour scale.
Operation 2 2.3 Setting slides Set the slides as follows: • Push the slides inwards for heating periods (3a). • Pull the slides outwards for periods without heating (3b). 2.4 Setting the heating program • Set the slides as desired and set the operating mode switch (5) to the automatic heating program “ ”. timeSWITCH 150 24-hour timer operating manual 2.5 Weekend mode • Turn the operating mode switch to “on” if the boiler is to be permanently on, during the weekend for example.
2 Operation; 3 Recycling and disposal 2.7 Power failure The timer cannot be operated with batteries. The clock is switched off in the event of a power failure. The set program is retained however. The preset program is resumed once the timer is supplied with power again. 3 Recycling and disposal Neither the timer nor any of its accessories belong in the household waste. Make sure the old device and any existing accessories are disposed of properly.
Information on the installation and operation 4 Installation manual 4 Information on the installation and operation All electrical work should be carried out by a specialist in accordance with the BS 7671 standard (IEE installation guidelines). 4.
4 Information on the installation and operation lant boilers with or without hot water supply. The timer is installed at the front of Vaillant ecoTEC combi boilers. Any other use or extended use is considered to be other than intended. The manufacturer/ supplier is not liable for any resulting damage. The heating engineer and/or the owner alone bear the risk. Intended use includes the observance of the operating and installation manual. All Vaillant boilers are equipped with an anti-freeze thermostat.
Safety instructions and regulations 5 5 Safety instructions and regulations The device must be installed by an approved company specialised in heating engineering, which is responsible for compliance with existing standards and regulations. We accept no liability for any damage caused by failure to observe these instructions. timeSWITCH 150 24-hour timer installation manual 5.
5 Safety instructions and regulations; 6 Installation 5.2 Regulations All wiring must be in accordance with Building Regulations Part P and BS 7671 (IEE Wiring Regulations), and must be carried out by a suitably qualified person. 6 Installation The timer is connected to the boiler by pin header connectors on the timer. The timer is pushed directly into the installation recess provided for this purpose, establishing an electrical connection to the boiler in the process.
Installation 6 • Switch off the boiler. • Disconnect the appliance from the power supply. • Undo the cover from the switch box. • Check which type of electronics box the boiler has: 1 2 If there are vertical plug connections with pins on the electronics box: • Carefully press the timer into the connection in the electronics box. If there are horizontal plug connections without pins on the electronics box: Fig. 6.
6 Installation; 7 Start-up • Insert the short ends of the 4-pin header connector (2) included with the timer into the four horizontal openings on the PCB for the timer (1). • Carefully press the timer unit with the pin header connector into the connection in the electronics box. 16 7 Start-up • Switch on the power supply for the boiler. • Put the boiler into service in accordance with the operating and installation manual of the boiler.
Handing over to the owner 8 8 Handing over to the owner You must show the owner how to handle the timer and inform the owner about its functions. Please use this checklist: Handover Done Hand over any instructions intended for the owner as well as the documents of the appliance and device. Go through the operating manual with the owner and answer any questions. Draw special attention to the safety instructions, which the owner must follow.
9 Customer service and warranty 9 Customer service and warranty Vaillant service To ensure regular servicing, it is strongly recommended that arrangements are made for a Maintenance Agreement. Please contact Vaillant Service Solutions (0870 6060 777) for further details. Vaillant warranty We only grant a Vaillant manufacturers warranty if a suitably qualified engineer has installed the system in accordance with Vaillant instructions.
Technical data 10 10 Technical data Operating voltage Current consumption Approx. weight Protection class Protection class for controller Unit V DC mA g Value 24 35 200 IP 20 II Table 10.
Fabricante - Manufacturer - Fabricante 838311_04 GBIEESPT 122011 Subject to change - Reservado o direito a alterações Reservado el derecho a introducir modificaciones - Proveedor - Supplier
