Technical data

4 Installation and maintenance instructions ecoTEC plus 937 0020031552_06
1 Notes on the documentation
The following information is intended to help you
throughout the entire documentation.
Further documents apply in combination with this instal-
lation and maintenance manual.
We accept no liability for any damage caused by failure
to observe these instructions.
1.1 Documents also having validity
Always observe all installation instructions for struc-
tural parts and components of the system when
installing the ecoTEC plus 937. These installation
instructions are enclosed with the various system
components as well as additional components.
Also observe all the operating instructions included
with the system components.
1.2 Storing documents
Pass these installation instructions and all other
applicable documents and, if necessary, any required
aids to the system operator.
He will be responsible for storing them so that the
instructions and aids are available when required.
1.3 Symbols used
The symbols used in the manual are explained below:
a
Symbol denoting danger
imminent danger to life
Risk of severe personal injury
Risk of slight personal injury
–
–
–
e
Symbol denoting danger
Risk of death from electric shock–
b
Symbol denoting danger
Risk of material damage
Risk of damage to the environment
–
–
i
Symbol denoting additional useful tips and
information
> Symbol for a required task
>
>
>
1.4 Validity of the manual
This installation manual applies exclusively to the unit
with the following part number:
0010003809
The part number of the unit can be obtained from the
identification plate. The 7th to 16th digits of the serial
number form the article number.
1.5 Identification plates
The identification plate of the ecoTEC plus 937 is
located on the underside of the unit.
1.6 CE label
CE labelling shows that the appliances comply with the
basic requirements of the following directives:
Directive 2009/142/EEC of the Commission with
revisions
"Directive for Harmonisation of Legal Regulations of
the Member States for Gas Consumer UNits"
(Gas equipment directive)
Directive 92/42/EEC of the Commission with revi-
sions
"Directive Concerning the Efficiency of New Hot
Water Heating Boilers Fired by Liquid or Gaseous
Fuels“ (Efficiency directive)
Directive 2006/95/EEC of the Commission with
revisions
"Directive Concerning Electrical Operating Equipment
for Use Within Specific Voltage Limits“
(Low voltage directive)
Directive 2004/108/EEC of the Commission with
revisions
"Directive Concerning Electromagnetic Compatibility"
The units comply with the prototype described in the EU
Prototype Test Approval:
PIN-No. CE-0085BP0464
The units comply with the following standards:
EN 483
EN 625
EN 677
EN 50165
EN 55014
EN 60335-1
EN 60529
EN 61000-3-2
EN 61000-3-3
–
–
–
–
–
–
–
–
–
–
–
–
–
–
1 Notes on the documentation