QuickSpecs
HP 16GB (1x16GB) Dual Rank x4 PC3-14900R (DDR3-1866) Registered CAS-13 Memory
Kit
708641-B21
HP 16GB (1x16GB) Dual Rank x4 PC3L-12800R (DDR3-1600) Registered CAS-11 Low
Voltage Memory Kit
713985-B21
Load Reduced DIMMs (LR DIMMS)
HP 32GB (1x32GB) Quad Rank x4 PC3-14900L (DDR3-1866) Load Reduced CAS-13
Memory Kit
708643-B21
Memory Expansion Options
HP DL580 Gen8 12 DIMM Slots Memory Cartridge
NOTE:
Up to Eight (8) memory cartridges are supported for 96 DIMM slots
NOTE:
A minimum of two memory cartridges are required (one per processor).
NOTE:
A minimum of two memory DIMMs are required per cartridge (minimum of four
DIMMs per server).
732411-B21
HP Networking
FlexibleLOM Adapters
NOTE:
Only one FlexibleLOM can be added to the server. These options are upgradeable
and can be changed from the original configuration after the server is shipped.
NOTE:
For 10Gb adapters, a minimum of two Gigabytes (2 GB) of server memory is
required per each adapter.
HP Ethernet 1Gb 4-port 331FLR FIO Adapter
684208-B21
HP FlexFabric 10Gb 2-port 534FLR-SFP+ FIO Adapter
700752-B21
HP Ethernet 10Gb 2-port 560FLR-SFP+ FIO Adapter
684218-B21
FBWC Upgrade for
embedded P830i
Controller
HP 2GB FIO Flash Backed Write Cache
758836-B21
HP 4GB FBWC FIO Kit for P-series SA
698537-B21
HP Power Supplies
NOTE:
Prior to making a power supply selection it is highly recommended that the HP
Power Advisor is run to determine the right size power supply for your server
configuration. The HP Power Advisor is located at:
www.hp.com/go/hppoweradvisor
.
HP Common Slot Platinum Plus Power Supply Kits
NOTE:
94% efficiency with support for HP Power Discovery Services.
HP 1500W Common Slot Platinum Plus Hot Plug Power Supply Kit
684532-B21
HP 1200W Common Slot Platinum Plus Hot Plug Power Supply Kit
656364-B21
NOTE:
Minimum of two (2) power supplies are required.
All power supplies in a server should match. Mixing Power Supplies is not supported.
NOTE:
Option Kits contain the specified power supply and a PDU IEC cable.
NOTE:
1500W Power Supplies only support High Line Voltage.
NOTE:
HP ProLiant servers ship with an IEC-IEC power cord used for rack mounting with
Power Distribution Units (PDUs). For a full list of optional HP power cords please go to
www.hp.com/products/powercords
QuickSpecs
HP ProLiant DL580 Generation 8 (Gen8)
Configuration Information - Factory Integrated Models
DA - 14743 North America — Version 1 — February 18, 2014
Page 23