Programming instructions

41
Installer Testing
Radio Status Mode
✓ NOTE: GSM Module must be installed to use this function.
The GSM Radio Status screen displays data for the GSM radio
(if installed). The screen displays signal strength, serial number,
registration status, and other information about the GSM radio
module status. The information may be helpful for radio installation
troubleshooting.
Follow these steps to check the radio status:
1. From the Installer Toolbox screen, press the RADIO STATUS button.
2. The system will display the GSM Radio Info screen. Each
test item is displayed, followed with its current condition.
Scroll through the info screen with the ↓ and ↑ arrows.
• Text is displayed in red if the tested signal strength is zero
or too low, or the GSM module is not registered.
• Text is displayed in orange if the connection is
idle and the GSM module is registered.
• Text is displayed in green if the signal strength is
good and the GSM module is registered.
GSM Radio Test
A RUN RADIO TEST button is provided on the GSM Radio Status
screen. Pressing this button will test the GSM cell phone connection
to the Central Station.
The same test can also be run using the CELL PHONE TEST button
on the User Toolbox screen #3.
Follow these steps to test the GSM radio:
1. From the Radio Status screen, press the RUN RADIO TEST button.
2. The system will display the Cell Phone Test screen. The top portion
of the screen shows the actions that the Control Panel is taking.
The bottom portion of the screen shows the results of the actions.
Scroll through the status screen with the ↓ and ↑ arrows.
3. When the test is complete, press OK to return to the Installer Toolbox.
Telephone Test
The telephone test checks the land-line connection to the Central
Station through the Control Panel’s built-in digital communicator.
The test is accessed through the User Toolbox screen #3.
Follow these steps to test the digital communicator:
1. On toolbox screen #3, press the TELEPHONE TEST button.
2. Enter the Master User Code, and the system will display the
Telephone Test screen. The top portion of the screen shows
the actions that the Control Panel is taking. The bottom
portion of the screen shows the results of the actions. Scroll
through the status screen with the ↓ and ↑ arrows.
3. When the test is complete, press OK to return to the User Toolbox.
Figure 71. Installer Toolbox Screen
Figure 72. GSM Radio Info Screen
Figure 73. GSM Radio Test Screen