Installation and User Guide PRESENTERPOD™ Preset Trigger System for the Vaddio™ Automated Content Presentation Systems Part Numbers: 999-1111-000 North America 999-1111-001 International ©2011 Vaddio - All Rights Reserved ● PresenterPOD System ● Document Number 342-0212 Rev.
PresenterPOD System Inside Front Cover -Blank PresenterPOD System ● Document Number 342-0212 Rev.
PresenterPOD System PresenterPOD Overview: The PresenterPOD is a perfect complement to the Vaddio AutoPresenter™ or ControlVIEW™ XHD video switcher and automated camera control systems and the Hot-Shot Preset Camera Controller. The system allows the presenter to walk up to a work area such as a lectern, teaching station or whiteboard and quickly have access to the AutoPresenter inputs, Pan/Tilt/Zoom camera presets and even the PIP on/off.
PresenterPOD System Unpacking: Carefully remove the products and all of the parts from the packaging. Part Number 999-1111-000 (North America) • • • • • One (1) PresenterPOD Interface 998-1111-000 One (1) PresenterPOD 998-1111-002 with Hardware o Two (2) Metal Wall Mount Tabs o Two (2) 6-32 x 5/16” Black Phillips FH Screws o Two (2) 800-617 Spiral Wall Anchors (EZ Anchor type) o Two (2) #8 x 1.25” Black Phillips PH Sheet Metal Screws One (1) 12VDC, 1.
PresenterPOD System The PresenterPOD Interface - Single PresenterPOD System (no scale) ➊ ➋ ➑ ➎ ➌ ➍ 5a 5b 5c 5d 5e ➏ ➐ Cat-5e Cable 5d 5a 5b 5c PresenterPOD 1 (no scale): Buttons marked to correspond to the icons on the Trigger Outs of PresenterPOD 1. The PresenterPOD is connected to the POD 1 Interface with a Cat-5e cable (up to 100’ /30.48m). 1) 2) 3) 4) Power LED: Blue LED power indicator light Power Jack: 5.5mm OD x 2.
PresenterPOD System PresenterPOD I/O The PresenterPOD has two (2) RJ-45 connection points for flexibility in mounting and cabling. Use only one of these connectors at a time. The Cat-5e cable between the PresenterPOD and the PresenterPOD Interface carries power to the POD and exchanges data with the interface. The bottom has an RJ-45 jack used when the PresenterPOD can be located on a wall, next to a whiteboard, and the Cat-5e cable can be run in the wall.
PresenterPOD System Basic System Connectivity Example 1: Once the PresenterPOD is connected to the PresenterPOD Interface, the triggers can be connected to the device to be activated (AutoPresenter, ControlVIEW XHD, Hot-Shot Preset Camera Controller, ProductionVIEW HD or other control systems). In this example, the Vaddio AutoPresenter is shown below. PresenterPOD 1 PresenterPOD Interface Cat-5e Cable up to 100’ (30.
PresenterPOD System Installation (continued): Sometimes, one PresenterPOD is just not enough. This is exactly the reason that one (1) PresenterPOD Interface can support two (2) PresenterPODs. The 2-POD System (2nd Pod sold separately) is as easy to connect as the 1st PresenterPOD. Connect PresenterPOD 2 in the POD 2 RJ-45 jack and connect the triggers to the trigger device as noted in the previous example.
PresenterPOD System General Specifications PresenterPOD System Part Numbers PresenterPOD Attributes: PresenterPOD Interface: Connectivity Labeling Power Supply Dimensions Weights 999-1111-000 North America 999-1111-001 International • Blue back-lit logo button that turns red when triggered • Three (3) manual buttons with blue LED backlights • Two (2) RJ-45 jacks (back and bottom) to connect to the PresenterPOD Interface with one (1) Cat-5e Cable • NOTE: use only one RJ-45 at a time on the PresenterPOD •
PresenterPOD System Compliance and CE Declaration of Conformity - PresenterPOD System Compliance testing was performed to the following regulations: • • • • • • FCC Part 15, Subpart B ICES-003, Issue 4: 2004 European Standard EN 55022 A: 2006 + A1: 2007(CISPR 22:2005/A1:2005) AS/NZS CISPR 22: 2009 VCCI V-3/2010.
PresenterPOD System PresenterPOD System Notes: PresenterPOD System ● Document Number 342-0212 Rev.
PresenterPOD System 9433 Science Center Drive, Minneapolis, MN 55428 Toll Free: 800-572-2011 ▪ Phone: 763-971-4400 ▪ FAX: 763-971-4464 www.vaddio.com ©2011 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited. Specifications and pricing are subject to change without notice. Vaddio, PresenterPOD, EZCamera, WallVIEW, AutoPresenter, Hot-Shot, Squiggle, ControlVIEW, ProductionVIEW, ClearVIEW, Quick-Connect and PowerRite are trademarks Vaddio.Rev.
