Owner manual
page 31 of 74
• Coolant valve
”detect”
• Provides fully automatic boiling point determination and switches an
in-line valve and/or a pump to maintain that pressure in two-point con-
trol.
• Coolant valve
’’Program’’
• Control in-line valve or pump based on time and pressure preselec-
tions.
• Coolant valve
• Venting valve
”VACUULAN”
• Switches a pump (VMS, see ”Accessories”, pg. 63, required) and
an in-line valve depending on preselected pressure and time settings.
• Coolant valve
’’Conguration’’ (also accessible by pressing the selection knob while
the start display is shown)
Preselections for
• Adjustment of the pressure transducer
• Interface RS-232
• Sensors (conguration and switching between several sensors)
• Display (brightness and contrast of the display, language, sound)
• Autostart (automatic restart after power failure)
• Defaults (reset the controller to factory set values)