Owner manual

page 15 of 74

Assemble and lock the suitable power plug (included in

shipment) to the power supply prior to use.

The controller is equipped with a short-circuit-proof, wide-

range power supply with an integrated overload protec-

tion.

Position the controller and its vacuum line in such a way

that condensate cannot ow towards the pressure trans-

ducer.

In case connect inert gas at the venting connection.

Allow the equipment to equilibrate to ambient temperature

if you bring it from cold environment into a room prior to

operation. Notice if there is water condensation on cold

surfaces.

Comply with all applicable and relevant safety require-

ments (regulations and guidelines). Implement the re-

quired actions and adopt suitable safety measures.

Ambient conditions

➨ Do not reach for this product if it has fallen into liquid.

There is a risk of deadly electrical shock. Unplug the

system immediately.

+ Do not use this product in an area where it can fall or

be pulled into water or other liquids.

• Adopt suitable measures in case of differences from

recommended conditions, e.g., using the equipment

outdoors, conductive pollution or external condensa-

tion.

• Do not operate this product near ames.

To the best of our knowledge the equipment is in com-

pliance with the requirements of the applicable EC-direc-

tives and harmonized standards (see ”Declaration of Con-

formity”) with regard to design, type and model. Directive

NOTICE